What are the steps of changing a strut?
- How to Tell If You Need New Struts.
- Measure the Camber Angle.
- Loosen and Remove the Nuts and Bolts.
- Separate the Strut and Knuckle.
- Remove the Strut Mount Nuts.
- Install the New Strut and Reset the Angle.
Can I change my struts myself?
The good news is, some repairs are easy to do at home. Like replacing shocks and struts. It’s not a job that you should attempt if you’re not familiar working with vehicles, but with a little training and experience, you’ll be ready to tackle the job.
How many miles do Honda struts last?
50,000- to 75,000-Mile Lifespan To ensure a safe and more comfortable drive, some manufacturers recommend replacing the struts and shocks every 50,000 to 75,000 miles. It is recommended to at least inspect the struts at this interval or annually for dents and leaks.
Can I just replace strut mount?
In some cars, a strut bearing comes with a strut mount as one unit; in other cars, it can be replaced separately, although the labor is the same. Strut mounts are also replaced if they show excessive corrosion or if the visible rubber part looks ripped or badly worn.
How easy is it to replace strut mounts?
Step by step: Replacing a strut mount
- Step 1 – Remove the wheels.
- Step 2 – Remove the suspension strut and clamp the fixture.
- Step 3 – Compress the suspension spring using a spring tensioner.
- Step 4 – Remove the nut on the damper connecting rod.
- Step 5 – Position the new strut mount in its installation position.
Do I need to replace springs with struts?
Should you replace coil springs each time you replace shocks or struts? Absolutely not. Inspect the coils every time you replace any suspension component. Ball joints, tie rod ends, idler arms, pitman arms and control arms that are compromised can all wreak havoc on the coil spring and shock or strut.
Can you compress a strut by hand?
You cannot judge the strength or condition of a shock/strut by hand movement alone. The force and speed generated by a vehicle in operation exceeds what you can accomplish by hand. The fluid valves are calibrated to operate differently depending on the degree of movement inertia which cannot be duplicated by hand.
How do you remove the rear strut on a Honda Accord?
Then loosen the nut with a socket and ratchet. Push the end link out of the strut hole and move it to the side. Disconnect the wheel speed sensor wiring harness and put that aside. Lean in and put some muscle into loosening the strut nuts.
How do you replace a strut on a car?
Make sure to include any rubber parts from the old strut. Install the strut bearing over the spring and install the new strut rod nut to the manufacture specified torque while holding the strut rod to prevent spinning the strut shaft. Again, if you’ve purchased a quick-strut, don’t worry about monkeying around with the spring on the old strut.
How do you lubricate a strut mount?
Apply penetrating oil to the strut nut and strut stem on top of the strut mount. Using a box wrench or pass-through socket wrench, torque the nut off while holding the strut stem with a ratchet wrench and socket or another box wrench.
Can you remove the center nut on a strut assembly?
Do not remove the center nut or the strut will come apart and it is under high spring tension. Since you’ve removed the bolts from the steering knuckle, the strut might fall loose after you remove these bolts. It might help to have a partner holding onto the strut assembly while you loosen these bolts.