Can you drag a plasma cutter?
You can simply drag the end of the plasma torch along a template or a straight edge. This process usually ensures a more accurate cut. 2. Drag cutting produces less spatter and blow back and this improves the life of the front end torch parts.
How do you use a drag tip on a plasma cutter?
Using plasma cutter drag tips If your machine uses a pilot arc, hold the tip about an inch away from the workpiece. Once ready, pull the trigger and drag your torch along the workpiece until your cut is complete. Remember that drag tips are consumable parts, so be prepared to change them out as needed.
Should plasma cutter tip touch the metal?
The plasma cutter drag tip is a type of a cutting tip that protrudes from the tip of your plasma torch which the PT-31 torches are generally equipped with. The best thing about having the plasma cutter drag tips is you can cut thin metal easily with it while dragging the tip along the metal.
Why does my plasma cutter leave slag?
High-Speed Dross and Slag High-speed dross occurs, as its name implies, is when the cutting speed is too high. Higher speeds causes the CNC plasma arc to fall behind the torch, leaving hard globs of uncut metal on the bottom of the plate and requiring tenacious cleanup.
Where are Hobart plasma cutters made?
Appleton, Wisconsin
Hobart machines are American-made in Appleton, Wisconsin. The Airforce 27i plasma cutter is also CSA Certified. This machine features an ergonomic torch design and 12-foot leads on both the torch and the ground lead. The Hobart Airforce 27i features a built-in regulator, air filter and water separator.
Does the Hobart 27i have a built in compressor?
No the 27i does not have an onboard air compressor. The model 12ci does, though.
What is a drag cup for plasma cutter?
How do you get less slag on a plasma cutter?
Solutions:
- Replace worn cutting tip, especially if the orifice shows signs of wear.
- Decrease the speed of your cut incrementally until dross in minimized.
- Lower the torch height incrementally.
- Boost current, being careful not to exceed 95% of your nozzles AMP rating.
How thick of metal can a 50 amp plasma cutter cut?
1/2-inch thick
This inverter plasma cutter has 50 amps of power on tap, able to cut up to 1/2-inch thick steel plate.
What plasma cutters are made in the USA?
What plasma cutters are made in the USA? Hypertherm and Miller are two famous plasma cutter brands assembled and built in the USA. Hypertherm is being made in New Hampshire, USA, and Miller is produced in Wisconsin.
What is the warranty on Hobart plasma cutters?
5/3/1 WARRANTY applies to all Hobart welding equipment, plasma cutters and spot welders with a serial number preface of MC or newer. This limited warranty supersedes all previous Hobart warranties and is exclusive with no other guarantees or warranties expressed or implied.
Where can I find a complete parts list for Hobart welders?
New Worn 5 *Pit Depth Electrode Wrench A complete Parts List is available at www.HobartWelders.com OM-243 974 Page 32 6-7. Torch And Work Cable Connections
What is an Hobart product?
HOBART PRODUCTS ARE INTENDED FOR PURCHASE AND USE BY COMMERCIAL/INDUSTRIAL USERS AND PERSONS TRAINED AND EXPERIENCED IN THE USE AND MAINTENANCE OF WELDING EQUIPMENT.