How do I drain my ecomax 400?

The drain down button is next to power on button, to it’s left, also as shown in the video. To drain the unit down, hold this button down for 5 seconds. This unit will then rinse itself out, after draining and ready for a member of staff to clean.

How do I reset my Hobart ecomax dishwasher?

Priming Operation Reset Instructions

1. Option 1. Press the WASH key again while the wrench and “empty chemical” icon flashing.
2. Option 2. Turn the machine off and wait about 10 seconds before turning it back on.

How do I reset my Hobart dishwasher?

If they are, try resetting the machine by doing either of the following:

1. Option 1. Press the WASH key again while the wrench and “empty chemical” icon flashing.
2. Option 2. Turn the machine off and wait about 10 seconds before turning it back on.

How do you troubleshoot a Hobart dishwasher?

Troubleshooting Tips for Hobart Dishwashers

1. Machine is turned off – turn it on.
2. Blown fuse or circuit breaker at the power supply – reset or replace it.
3. Power cord is unplugged or disconnected – reconnect it.
4. Door is jammed or not closed – inspect door seals and remove obstructions.

How do you Delime a commercial dishwasher?

How to Descale a Commercial Dishwasher

1. Fill the machine with water.
2. Add the descaling product according to the product instructions.
3. Allow the product to sit for one hour.
4. Run a full wash cycle.
5. Inspect the dishwasher to see if it has been properly descaled.

How do you sanitize a commercial dishwasher?

How to descale your commercial dishwasher.

1. Drain the dishwasher and refill with fresh water.
2. Add 500ml of a good quality descaler to the wash tank and run for 10 minutes.
3. Inspect and run for a further 10 minutes if needed.
4. If there is any heavy build-up use descaler neat with a scourer to remove heavy deposits.

What does P2 mean on a Hobart dishwasher?

P1 is wash and P2 is rinse.

How often should you Delime a commercial dishwasher?

0. It’s generally recommended that you run a descaling cycle (or deliming cycle) once every week. Switch your machine into deliming mode and add deliming solution (consult your user’s guide, or speak with your supplier/manufacturer for details on safe deliming solutions for your equipment).

https://www.youtube.com/watch?v=GGAPdOyRShs