How do I reset my DSC control panel?
To reset the detectors, press and hold the Reset key for two seconds or press *72.
How do I set a default DSC panel?
To hardware default the DSC PowerSeries Panel, disconnect both AC and battery to power down….How Do I Default My DSC PowerSeries Alarm Panel?
- Prepare the terminals.
- Power panel down.
- Short across terminals.
- Apply AC power.
- Remove AC power.
- Remove the jumper.
- Restore power.
Where is the reset button on my DSC alarm system?
This button is usually located on the bottom right side of the keypad. Hold it down for at least 2 seconds to disengage the alarm. You will notice the lights on the alarm change from red to green to signal that the alarm has been reset.
How do I reset my home security code?
How to reset a house alarm after a power cut?
- Locate the “System” or “System Status” button. On your home alarm keypad, find the “System” or “System Status” button.
- Open the control panel.
- Remove the backup battery.
- Switch the circuit breaker off and on.
- Replace the backup battery.
- Input your user code.
How do you broadcast labels on DSC keypad?
Perform the following procedure in order to broad- cast labels: Step 1 – Program one LCD keypad completely. Step 2 – Make sure all LCD keypads are connected to the Keybus. Step 3 – Enter keypad programming by pressing [,][8][Installer Code][,], then enter section [998] at the keypad that was programmed.
How do I set the date and time on my DSC alarm?
Time & Date Programming In the event that you need to reset the time and date on your keypad, press [*] [6] [Master Code], then press [1] to select Time and Date. Enter the time in 24 hr format (HH:MM) followed by the date (MM:DD:YY). Press # to exit programming.
Where is the reset button on a DSC alarm?
What is DSC master code?
Default Master and Installation codes for DSC systems The default master code for these systems is 1234. Most likely that’s been changed so you will need to get into the programming area of the panel to change it to what you want.