How do you drive a steam loco in Train Simulator?
In Train Simulator 2013 the default control display is the HUD (Head-Up Display) that is enabled with the [F4] key on your keyboard. This shows the status of the scenario and the train and also provides mouse-operable controls to allow you to drive the locomotive.
How do you start a steam train?
Open the throttle to start the engine moving – the very long lever close to your face and hanging from the cab roof is the throttle. Grip it firmly and give it a yank towards you. As you feel the engine move slightly, shove it back in most of the way, so that it does not gather speed too fast.
How do you get trains to move in Train Simulator?
Anyways, to get the train moving just move the lever highlighted in blue towards the right. You will need to get out of your seat to be able to access this.
How do steam locomotives work?
When heated, water turns to an invisible vapor known as steam. The volume of water expands as it turns to steam inside the boiler, creating a high pressure. The expansion of steam pushes the pistons that connect to the driving wheels that operate the locomotive.
How do steam engine injectors work?
It uses the Venturi effect of a converging-diverging nozzle on a steam jet to convert the pressure energy of the steam to velocity energy, reducing its pressure to below that of the atmosphere, which enables it to entrain a fluid (e.g., water).
How do you change controls on Train Simulator?
- Pantograph Up | Down P or Shift + P (cycle front Up – both up – back up)
- Main switch press Ctrl + Z.
- Set Reverser press W | S keys.
- Driving AFB Control Mode. Power Level set press C | Y keys – adjust.
- Driving NOTCHED Control Mode – SHUNTING. Regulator to zero press “A” key.
- Driving Modes.
- Braking.
How do you steam locomotives work?
Can you drive a locomotive on the road?
It would be almost impossible to drive a train on the road. Steel wheels on the train would sink right into the road surface, and the engine would be unable to move at all. Steel tyres are not designed to carry the weight of a train engine on a concrete freeway even when it is high load bearing.
What does an MU 2A valve do?
The MU-2A valve has three positions: LEAD or DEAD—Engages control of the independent brakes. Use when a locomotive is a single unit, a controlling unit, or is being hauled dead-in-tow. TRAIL 6 or 26—Disconnects control of the independent brakes from the independent brake valve.
How to drive a steam locomotive?
In order to drive a steam locomotive it is necessary to know the basics mathematics and techical aspects of steampower. reassign the key assigments in the MSTS game options. When you still use MSTS, you better reassign your keyboard. The left side of an USA standard keyboard (QWERTY) is suited for stoking purposes.
How long does it take to become a steam locomotive driver?
How long does it take to become a driver of a steam locomotives? Depends on your country, but typically most train drivers (steam, diesel, and electric) are trained for about 2 years before becoming fully-qualified train drivers. Thanks! Does the engineer actually drive the train?
How steam locomotives are made?
After lifting up the boiler and frame, the wheel sets are rolled in place manually. The frame and boiler are now lowering down over the axles until the complete frame is resting in the wheel bearers. This is one of the main fabrication processes of the steam locomotive and is also a part of the maintenance process as well.
How to prepare a steam locomotive in cold state?
Preparing a steam locomotive in cold state takes a lot of time. First of all take away the chimney cover or chimney lid and close all valves to keep the pressure when the pressure starts to rise. Prior to firing up you test the water level and the water scope if these instruments are working properly.