How do you put a boat in a bunk trailer?
Loading a Boat onto Your Trailer
- Back the trailer in so the bunks get wet completely.
- Pull forward to a point where roughly a third of the center bunks are out of the water.
- Nose the bow of the boat between the bunks.
- Winch forward until the bow eye is up against the bow rollers.
- Slowly pull the boat out of the water.
How far apart should bunks be on a boat trailer?
1/2″
For bunks, the gap between bunks and strakes should be 1/2″.
How far do you back a boat trailer into the water?
about two-thirds
It should be just about as deep as it was when taking the boat off, and in most cases, about two-thirds of the trailer will be submerged while one-third remains out of the water. Don’t submerge the trailer too deep, or the bow of the boat may float over the bunks and go off to the side.
Why should a boats gas tank never be completely filled?
It’s important to never fill the tank of your boat beyond 90% full. This leaves room for gas to expand and avoids the potential for overflow. Ensure that all air vents and valves to the gas tank are open.
How do you load a boat by yourself?
How to Load a Boat on a Trailer By Yourself
- Tie up your boat to the dock.
- Then attach a single long line to the bow and stern cleat.
- Back the trailer down deep enough that you can float the boat most of the way onto the trailer.
- Using the line you can control the boat as you walk down the dock.
How do you load a boat without a dock?
Here are 4 simple steps to ensure a smooth launch without a dock.
- Step 1: Inspect the ramp and prep your boat.
- Step 2: Tie a bow line to your trailer or truck.
- Step 3: Back down the ramp until the boat floats.
- Step 4: Pull forward and gently bring the boat to shore.
How do you load a boat on your own?
How to Load a Boat by Yourself
- Tie the Boat Off at the Back of the Dock and Back Your Trailer Straight Down the Middle of the Ramp.
- Get on Your Boat, Untie the Rope and Give a Small Shove Off the Dock.
- Drive the Boat Up the Trailer and Attach it to the Trailer Winch.
How far back should a boat sit on a trailer?
Set boat on trailer while maintaining no less than 2″ gap between keel and tongue plate cover. The end of the bunks/rollers should be flush with transom and the boweye should reach the winch post. If this is so, the rear pivot should remain in the A-position.
What kind of wood is used for trailer bunks?
pressure-treated pine
For wood, pressure-treated pine is the industry standard for trailer bunks. Popular alternatives are oak, cypress and other hardwoods that add even more durability. Composite boards used for patio decking are other options, but pressure-treated pine is a proven material with economic benefits.