Does Power Commander make a difference?
this smooths out your power curve making power delivery better while gaining a few HP throughout the rev range, so in terms of making your bike run better, especially with an aftermarket slip on & filter, then yes it does make a difference.
How much HP do you gain with a Power Commander?
The Power Commander is a tuning tool to adjust fuel, and on some models ignition timing. Just adding a Power Commander to a completely stock vehicle usually does not increase peak horsepower. It usually will improve drivability, throttle response, and mid-range horsepower and torque.
What does a Power Commander do for a Harley Davidson?
The Power Commander V is a unique EFI tuning device because it can monitor and maintain your air/fuel ratio without directly changing the ECU. To reinstate your stock settings, all you need to do is uninstall the device, and you’re done.
Can a Power Commander hurt a motorcycle?
Can A Power Commander Hurt A Motorcycle? Power Commanders can damage bikes, but it is unlikely. Power Commanders allow you to adjust the air to fuel ratio of your motorcycle, which means you could set this so that the bike runs too lean on fuel.
Do you need to dyno tune a Power Commander?
yes you need a powercommander for a dyno tune. That is what they tune that controls how much fuel is pumped into your engine. You also should install block off plates. It may help with some of the popping as well.
How much does a Power Commander cost?
Compare with similar items
This item Dynojet (19-001 Power Commander V Fuel Injection Module | Dynojet (17-013 Power Commander V Fuel Injection Module | |
---|---|---|
Add to Cart | Add to Cart | |
Customer Rating | 5.0 out of 5 stars (1) | 5.0 out of 5 stars (1) |
Price | $42999 | $37999 |
Sold By | Racing Performance | Racing Performance |
Does Power Commander void warranty?
Will it void my warranty though when I install it? If you are in the United States then NO, it will not void your warranty. YMMV in other countries. You should call Dynojet, they will set you straight!
What is the purpose of a Power Commander on a motorcycle?
A Power Commander is a brand of fuel injection or ignition timing manufactured by Dynojet Research Inc. The Power Commander is used by motorcycles as a way of boosting their engine performance to a higher level of horsepower than a rider might get from the motorcycle’s stock engine performance.
How much does a Power Commander 5 cost?
Compare with similar items
This item Dynojet (19-001 Power Commander V Fuel Injection Module | Dynojet (17-004 Power Commander V Fuel Injection Module | |
---|---|---|
Add to Cart | Add to Cart | |
Customer Rating | 5.0 out of 5 stars (1) | (0) |
Price | $42999 | $37999 |
Sold By | Racing Performance | Racing Performance |
Can you reuse a Power Commander?
Life Member. Yes, you can move your PCV to the other bike as both bikes use the same one (Part # 15-011). You will however need to go to the Power Commander website and download a new map to the PCV that matches your current setup for the 2012.
Do you need Power Commander with full exhaust?
the only time you need mapping (power commander) is if you do anything to change the air/fuel ratio. the reason a slip-on does not need a power commander is because the exup valve (a servo controlled butterfly valve in your exhaust) is still in place and it manages exhaust flow and back pressure.