How do I update my deep sea software?
Enter your login details for the DSE Website. Click Ok to continue. Select the modules which are to be installed with the software. Click Update to continue.
How do I reset my DSE 7320?
ACCESSING THE MAIN CONFIGURATION EDITOR (Stop/Reset) button. Press the (Stop/Reset) and (Tick) buttons simultaneously. If a module security PIN has been set, the PIN number request is then shown: The first ‘#’ changes to ‘0’.
How do I download Deep Sea Electronics Software?
Software access and download location:
- Go to www.deepseaplc.com.
- Click Register in the upper right hand corner if not already registered.
- Click Login on the home page of Deep Sea’s website.
- Click Product Software link at the bottom of the page under the SUPPORT section.
- Select your Controller model and click Submit.
How do I reset my deep sea controller?
Ensure the engine is at rest and the module is in STOP mode by pressing the (Stop/Reset) button. Press the (Stop/Reset) and (Tick) buttons simultaneously. The first ‘#’ changes to ‘0’. Press the (Up) or (Down) button to adjust it to the correct value.
How do you fix a locked out generator?
Power off the generator: The reset switch should look like a regular switch. Please turn off the switch and again turn it on to reset the generator.
What is DSE module?
DSEGenset® is an intelligent range of single-set and multi-set generator control solutions, mains (utility) protection relays, lighting tower control solutions, digital automatic voltage regulators (AVR’s), remote communications devices and expansion modules.
How do you reset a Deep Sea Electronics generator?
The method of reset is either by: Activating an input that has been configured to Maintenance Reset Alarm 1, 2 or 3. Pressing the maintenance reset button in the DSE Configuration Suite, Maintenance section. Mode button for 10 seconds on the desired Maintenance Alarm status page.
How do I reset my emergency stop on my generator?
Become a Fan
- The red blinking light means there is an active alarm.
- Select the events log key.
- Select genset control and press ok.
- Scroll down using the directional keys until you see the emergency stop shutdown active screen.
- Press ok and the red light will turn off and the alarm will be cleared.