How do I use my AT remote?
Here’s all you need to do:
- With your TV on, use your U-verse TV remote and press Menu.
- Select Help > Information > Remote Control Setup.
- Next, select your remote control from the TV onscreen list. Refer to your specific remote for TV/device setup options.
- Select Top Ten Brand Setup, Automatic Code, or Manual Setup.
How do I program my AT remote to my TV?
Here’s how:
- Open DIRECTV STREAM on your TV device.
- Choose Settings and then System.
- Select Remote & Devices, then Program Your Remote.
- Choose the TV manufacturer or sound bar you want to add.
- Follow the prompts to finish up.
Why is my AT TV remote not working?
Restart your receiver – Hold down the POWER button for 10 seconds then press it again to restart. This process will take 5-8 minutes and will impact any DVR recordings in progress. Order a replacement remote – visit the online Accessory store to order a replacement U-verse TV remote control.
How do I reset my AT TV remote?
Reset your remote by type and clear any programming Press and hold the AT and the OK key simultaneously. Release both keys and all four mode keys will flash twice to indicate you are in programming mode. Enter programming code 900 by pressing the number keys on the remote control.
How do I program my ATT Uverse remote to control the volume?
STEP 1: Enter Program Mode – Press and hold the oK and menu keys simultaneously for three seconds until the PoWer key flashes red twice to confirm you are in program mode. STEP 2: Press VOLUME UP – Press the Volume uP key.
Why is my AT remote flashing red?
If it flashes red 5 times each time you press a button, it is low on batteries.
Is ATT TV remote universal?
AT TV will work with universal remotes. It uses the same codes as the DIRECTV remotes.
How do I reset my AT RC73 remote?
To reset the RC73 remote: -Press and hold mute and select until the light blinks. -After releasing mute and select, type the numbers “9, 8, 1” in that order. -You should see the light blink again on the remote after typing the above 3 numbers.
How do I program my AT remote to my receiver?
Press and hold the remote’s OK and MENU buttons at the same time for about 3 seconds. Wait until all 4 arrow keys flash red twice and you hear 2 short beeps to confirm you’re in programming mode. Press the device button you wish to set up: TV, DVD, or AUX (for audio devices). The button will then light up and stay red.
Why is the power button on my remote red?
Almost sounds like a button got stuck in the down position – maybe that pause or power button. Look at the buttons on the remote (particularly the pause and power buttons) and see if any of them look like they are lower than any of the surrounding buttons and if so try to free them.
Can I use my phone as a remote for ATT TV?
Introduction to Easy Remote, The U-verse Easy Remote Android application allows you to connect your Android phone or tablet to your TV so you can use it as a remote control. It’s ideal for customers who want an easy-to-use device to control their U-verse TV.