How do you stagger Hardie siding?
It’s best to stagger the joints in each successive course to avoid noticeable patterns. Butt joints in adjacent courses should be spaced apart by at least two stud bays for 16-inch, o.c. framing or one bay for 24-inch, o.c. framing.
Do you nail or screw Hardie siding?
James Hardie prefers and recommends installation of HardiePlank® lap siding by the blind nailing technique, such that fasteners are hidden by the course above. Fasteners shall be installed between 1 in. and 3/4 in. from the top edge and no closer than 3/8 in.
How do you start Hardie shakes?
* 1) Find the center stud of your of your Gable and snap a caulk line down 2) Measure out 16”* to both the left and the right of the center line and snap a caulk line 3) Measure up 2” if you are off a roof line or ¼” if you are starting above a band board 4) Set the bottom of your 1 ¼” starter strip at that line 5) …
How do you install staggered shake siding?
How to Install Staggered Cedar Shake Siding
- Install Your Building Paper. Apply overlapping horizontal rows of building paper onto the shear wall, using a staple gun with 3/8-inch staples.
- Nail Your First Cedar Shake.
- Create Your First Row.
- Install a Second Row.
- Stagger Additional Rows of Shakes.
- Snap Off Unused Siding.
How many pieces of Hardie shake are in a square?
43 pieces
Pieces needed for one square (100 sq. ft.) of product coverage=43 pieces with 7″ exposure. HardieShingle Half-Round Panel Installation Install HardieShingle® panels with joints butted in moderate contact.
Does Hardie siding have to be nailed to studs?
GENERAL REQUIREMENTS: HardiePlank® lap siding can be installed over braced wood or steel studs spaced a maximum of 24″ o.c. or directly to minimum 7/16″ thick OSB sheathing. See General Fastening Requirements. Irregularities in framing and sheathing can mirror through the finished application.
Can I use a framing nailer for Hardie siding?
Yes, you can. You can use a framing nailer for hardie siding, but it takes some work. It is important to use the right nails, however. Framing nailers are a popular choice for many contractors and homeowners when it comes to installing siding.
What kind of nailer do you use for Hardie siding?
Best Overall: BOSTITCH Coil Siding Nailer The BOSTITCH Coil Siding Nailer has everything you need in a nailer for a hardie siding installation that will make heads turn. You’ll love the easy-to-use depth adjustment, consistent depth of nail drive, and smooth operation (no annoying misfires or jamb).
How much do you overlap Hardie shingle siding?
HardieShingle® Individual Shingle Installation Due to overlapping of the joints, caulk is not required except where panels about trim boards. Space shingles a maximum 1/4″ apart and leave a minimum lap of 1 1/2″ between successive courses (fig. 19).