What is the blue wire on a Sony car stereo?
IMPORTANT: If additional installation procedures or information is needed, contact a qualified car stereo installer….What is the wire color and function of each pin on the 16-pin wiring harness?
Pin Number | Wire Color | Function |
---|---|---|
5 | Blue or White | Amplifier Remote |
6 | Blue | Antenna Remote |
What is the yellow wire on a Sony car stereo?
The yellow wire is the 12 volt battery wire, which should also be attached to the stereo for power. The final wire, the black wire, is the ground wire. This wire, once attached to the stereo, will help ground it.
What is the orange wire on a car stereo?
The normal use of orange and orange/white wires is orange is for variable voltage to control display illumination dimming (i.e. the head unit display dims along with the other dash lights) while orange/white is a simple on/off signal of whether the dash lights are on (the head unit has only bright and dim display …
Where does the blue wire go on a car stereo?
The right-front speaker wires are gray, left-front speakers are white, right-rear speakers are purple, and left-rear speakers are green. Ground wires are black, antenna wires are blue, and amplifier wires are blue with a white stripe.
What color is the REM wire?
Wiring Harness Color Standards
Wire Color | Wire Function |
---|---|
Red | Switch / Accessory |
Black | Ground |
Blue | Antenna Remote |
Blue with White Stripe | Amplifier Remote Turn-on |
Where do you connect the yellow wire?
Blue and Yellow Electrical Wires Yellow wires are used as switch legs to ceiling fans, structural lights, and outlets paired with light switches, while blue wires are usually used as travelers for three-or-four-way switches.
How do you hook up a car stereo to a house plug?
On the car stereo, twist the red and yellow wires together. After you do that, connect the black ground wire on the stereo to the black wire on the pin connector. The stereo’s red and yellow wires connect to the connector’s yellow wire. You then follow the typical instructions to hook the stereo up to your speakers.
How do I hook up my car stereo to electricity?
To connect a car radio to a power supply you’ll need to do the following:
- Ground: Connect the radio’s ground wire (black wire) to the (-) power supply output.
- Main power: Connect the radio’s +12V battery wire (usually the yellow wire) to the (+) power supply output.